Starting the Generator Video Tutorial Included
Learn how to safely fire up the onboard Cummins Onan 6kW marine generator to power high-draw AC systems (such as air conditioning and watermaker).
Note: Completing the 3-minute Digital Safety Briefing is required to unlock your Smart Lock code for your first trip of the season.
15-Second Vessel Familiarization Snippet
Forget the 400-page paper manual.
8kts provides bite-sized, hull-specific video tutorials recorded during your boat's commissioning phase. From resetting the windlass breaker to switching the water tanks, master your vessel in minutes.
Step-by-Step Walkthrough
- 1
Open Generator Seacock
Locate the generator saltwater cooling inlet thru-hull valve under the salon floorboards and turn it to the parallel (open) position.
- 2
Perform Pre-Start Check
Verify generator oil level is in the safe range using the dipstick, and inspect the compartment for dry bilges.
- 3
Preheat & Start on Panel
On the main electrical board, hold the PREHEAT button for 5 seconds, then press and hold START until the diesel engine fires up. Allow the generator to run idle for 2 minutes.
- 4
Switch AC Source to Gen
Rotate the main AC selector dial from "Shore Power" to "Generator" on the master panel. Verify voltage reads 230V @ 50Hz.